Perlbal::Manual::LoadBalancer - Using Perlbal as a Load Balancer
How to configure a Perlbal Load Balancing service.
Please read Perlbal::Manual::Configuration first for a better explanation on how to configure Perlbal. This document will make much more sense after reading that.
For a better understanding of how to set up Perbal as a Load Balancer, it should be noted that a Load Balancer and a Reverse Proxy can often be the same thing; not always, but often.
A Load Balancer is a server (or device) that balances requests across a number of servers to spread the load. A Reverse Proxy can still do this but also have a number of other features.
Perlbal as a Reverse Proxy provides features such as buffering content, preserving connections to the backend servers, starting connections ahead of time and a high priority queue, among others.
You could almost say that a Load Balancer is a subset of a Reverse Proxy (it's not, but you could).
When it comes to Perlbal, the Load Balancer is implemented as a Reverse Proxy without all the extra options, and that's why you set the role of a Load Balancer to
SET role = reverse_proxy
Let's assume you want to configure two machines to serve your website and you want to let Perlbal decide how to balance the requests. For the sake of this exercise let's assume you have two servers at:
And now you want to use these two machines to serve your website at:
Here's a sample configuration to make this happen:
CREATE POOL mywebsite POOL mywebsite ADD 10.0.0.1:80 POOL mywebsite ADD 10.0.0.2:80 CREATE SERVICE service_mywebsite SET role = reverse_proxy SET pool = mywebsite SET listen = 10.0.0.3:80 ENABLE service_mywebsite
The first line defines a pool of machines called
mywebsite. The second and third lines add your two machines to that pool (note that the indentation is not mandatory).
After that you define a service called
service_mywebsite with the role
reverse_proxy set to listen on
10.0.0.3:80 and using the pool
mywebsite to serve the requests.
The last line is what allows you have several services configured in a file even if they are not currently active (a common scenario is to configure everything on the file and then enable/disable services on-the-fly as required; see Perlbal::Manual::Management for more information on this process).
Perlbal uses a highly efficient load balancing algorithm. It is very effective for distributing dynamic web requests among potentially heterogeneous hardware.
First, backend servers must have their MaxClients (for apache, or equivalent) setting tuned to a reasonable limit. If your hardware can run 20 requests in parallel before running out of CPU, set MaxClients to 20.
Next, by default Perlbal will distribute requests randomly. Opening a new connection to any available backend, and issuing the request.
The proper algorithm is able to be used if
connect_ahead are enabled.
SET persist_backend = on SET verify_backend = on SET backend_persist_cache = 5 SET connect_ahead = 2
In this configuration, Perlbal will only route client requests to backends that it knows are real processes, instead of the OS listen queue. It will attempt to reuse pre-verified backends, and will attempt to create slightly more idle connections than it needs in preparation of future requests.
When you put all this together, it becomes less likely that a client will wait for Perlbal to find an available backend. By setting your MaxClients properly, backends are able to serve traffic without getting overwhelmed. If no backends are available, Perlbal will queue them internally, rather than overload backends.
You would want to disable
verify_backend if you are balancing across image servers, or other extremely lightweight requests.