Config::Model::models::LCDd::serialVFD - Configuration class LCDd::serialVFD
version 2.041
Configuration classes used by Config::Model
generated from LCDd.conf
Set the initial brightness (4 steps 0-250, 251-500, 501-750, 751-1000)Optional. Type integer. upstream_default: '1000'.
Device to use in serial mode. Usual values are /dev/ttyS0 and /dev/ttyS1. Optional. Type uniline. default: '/dev/ttyS1'.
enable ISO 8859 1 compatibility Optional. Type boolean. upstream_default: 'yes'.
Set the initial off-brightness This value is used when the display is normally switched off in case LCDd is inactive (4 steps 0-250, 251-500, 501-750, 751-1000)Optional. Type integer. upstream_default: '0'.
Number of Custom-Characters. default is display type dependent Custom-Characters=0 Portaddress where the LPT is. Used in parallel mode only. Usual values are 0x278, 0x378 and 0x3BC.Optional. Type uniline. default: '0x378'.
Set parallel port timing delay (us). Used in parallel mode only.Optional. Type integer. upstream_default: '2'.
Specifies the size of the VFD.Optional. Type uniline. default: '20x2'.
set the serial port speed Optional. Type enum. choice: '1200', '2400', '9600', '19200', '115200'. upstream_default: '9600'.
Specifies the displaytype. 0 NEC (FIPC8367 based) VFDs. 1 KD Rev 2.1. 2 Noritake VFDs (*). 3 Futaba VFDs 4 IEE S03601-95B 5 IEE S03601-96-080 (*) 6 Futaba NA202SD08FA (allmost IEE compatible) 7 Samsung 20S207DA4 and 20S207DA6 8 Nixdorf BA6x / VT100 (* most should work, not tested yet.)Optional. Type uniline. upstream_default: '0'.
"no" if display connected serial, "yes" if connected parallel. I.e. serial by default. Optional. Type uniline. upstream_default: 'no'.
cme
To install Config::Model::LcdProc, copy and paste the appropriate command in to your terminal.
cpanm
cpanm Config::Model::LcdProc
CPAN shell
perl -MCPAN -e shell install Config::Model::LcdProc
For more information on module installation, please visit the detailed CPAN module installation guide.