Ishraq Ibne Ashraf
and 1 contributors

NAME

Tinkerforge::BrickletAnalogOut - Generates configurable DC voltage between 0V and 5V

CONSTANTS

DEVICE_IDENTIFIER

This constant is used to identify a Analog Out Bricklet.

The get_identity() subroutine and the CALLBACK_ENUMERATE callback of the IP Connection have a device_identifier parameter to specify the Brick's or Bricklet's type.

DEVICE_DISPLAY_NAME

This constant represents the display name of a Analog Out Bricklet.

FUNCTION_SET_VOLTAGE

This constant is used with the get_response_expected(), set_response_expected() and set_response_expected_all() subroutines.

FUNCTION_GET_VOLTAGE

This constant is used with the get_response_expected(), set_response_expected() and set_response_expected_all() subroutines.

FUNCTION_SET_MODE

This constant is used with the get_response_expected(), set_response_expected() and set_response_expected_all() subroutines.

FUNCTION_GET_MODE

This constant is used with the get_response_expected(), set_response_expected() and set_response_expected_all() subroutines.

FUNCTION_GET_IDENTITY

This constant is used with the get_response_expected(), set_response_expected() and set_response_expected_all() subroutines.

FUNCTIONS

new()

Creates an object with the unique device ID *uid* and adds it to the IP Connection *ipcon*.

set_voltage()

Sets the voltage in mV. The possible range is 0V to 5V (0-5000). Calling this function will set the mode to 0 (see :func:`Set Mode`).

The default value is 0 (with mode 1).

get_voltage()

Returns the voltage as set by :func:`Set Voltage`.

set_mode()

Sets the mode of the analog value. Possible modes:

* 0: Normal Mode (Analog value as set by :func:`Set Voltage` is applied) * 1: 1k Ohm resistor to ground * 2: 100k Ohm resistor to ground * 3: 500k Ohm resistor to ground

Setting the mode to 0 will result in an output voltage of 0. You can jump to a higher output voltage directly by calling :func:`Set Voltage`.

The default mode is 1.

get_mode()

Returns the mode as set by :func:`Set Mode`.

get_identity()

Returns the UID, the UID where the Bricklet is connected to, the position, the hardware and firmware version as well as the device identifier.

The position can be 'a', 'b', 'c' or 'd'.

The device identifier numbers can be found :ref:`here <device_identifier>`. |device_identifier_constant|