stag-diff - finds the difference between two stag files
stag-diff -ignore foo-id -ignore bar-id file1.xml file2.xml
Compares two data trees and reports whether they match. If they do not match, the mismatch is reported.
shows this document
these nodes are ignored for the purposes of comparison. Note that attributes are treated as elements, prefixed by the containing element id. For example, if you have
<foo ID="wibble">
And you wish to ignore the ID attribute, then you would use the switch
-ignore foo-ID
You can specify multiple elements to ignore like this
-i foo -i bar -i baz
You can also specify paths
-i foo/bar/bar-id
which parser to use. The default is XML. This can also be autodetected by the file suffix. Other alternatives are sxpr and itext. See Data::Stag for details.
report mismatches as they occur on each element of type ELEMENT
multiple elements can be specified
used in conjunction with the -report switch
shows the tree of the mismatching element
If a mismatch is reported, a report is generated displaying the subpart of the tree that could not be matched. This will look like this:
REASON: no_matching_node: annotation no_matching_node: feature_set no_matching_node: feature_span no_matching_node: evidence no_matching_node: evidence-id data_mismatch(:15077290 ne :15077291): evidence-id AND evidence-id
Due to the nature of tree matching, it can be difficult to specify exactly how trees do not match. To investigate this, you may need to use the -r and -v options. For the above output, I would recommend using
stag-diff -r feature_span -v
Both trees are recursively traversed... see the actual code for how this works
The order of elements is not important; eg
<foo> <bar> <baz>1</baz> </bar> <bar> <baz>2</baz> </bar> </foo>
matches
<foo> <bar> <baz>2</baz> </bar> <bar> <baz>1</baz> </bar> </foo>
The recursive nature of this algorithm means that certain tree comparisons will explode wrt time and memory. I think this will only happen with very deep trees where nodes high up in the tree can only be differentiated by nodes low down in the tree.
Both trees are loaded into memory to begin with, so it may thrash with very large documents
Chris Mungall cjm at fruitfly dot org
Data::Stag
1 POD Error
The following errors were encountered while parsing the POD:
=over should be: '=over' or '=over positive_number'
To install Data::Stag, copy and paste the appropriate command in to your terminal.
cpanm
cpanm Data::Stag
CPAN shell
perl -MCPAN -e shell install Data::Stag
For more information on module installation, please visit the detailed CPAN module installation guide.