Tinkerforge::BrickletRemoteSwitch - Controls remote mains switches
This constant is used to identify a Remote Switch Bricklet.
The get_identity() subroutine and the CALLBACK_ENUMERATE callback of the IP Connection have a device_identifier parameter to specify the Brick's or Bricklet's type.
This constant represents the display name of a Remote Switch Bricklet.
This constant is used with the register_callback() subroutine to specify the CALLBACK_SWITCHING_DONE callback.
This constant is used with the get_response_expected(), set_response_expected() and set_response_expected_all() subroutines.
Creates an object with the unique device ID *uid* and adds it to the IP Connection *ipcon*.
This function is deprecated, use :func:`Switch Socket A` instead.
Returns the current switching state. If the current state is busy, the Bricklet is currently sending a code to switch a socket. It will not accept any requests to switch sockets until the state changes to ready.
How long the switching takes is dependent on the number of repeats, see :func:`Set Repeats`.
Sets the number of times the code is sent when one of the switch socket functions is called. The repeats basically correspond to the amount of time that a button of the remote is pressed.
Some dimmers are controlled by the length of a button pressed, this can be simulated by increasing the repeats.
Returns the number of repeats as set by :func:`Set Repeats`.
To switch a type A socket you have to give the house code, receiver code and the state (on or off) you want to switch to.
A detailed description on how you can figure out the house and receiver code can be found :ref:`here <remote_switch_bricklet_type_a_house_and_receiver_code>`.
.. versionadded:: 2.0.1$nbsp;(Plugin)
To switch a type B socket you have to give the address, unit and the state (on or off) you want to switch to.
To switch all devices with the same address use 255 for the unit.
A detailed description on how you can teach a socket the address and unit can be found :ref:`here <remote_switch_bricklet_type_b_address_and_unit>`.
To control a type B dimmer you have to give the address, unit and the dim value you want to set the dimmer to.
A detailed description on how you can teach a dimmer the address and unit can be found :ref:`here <remote_switch_bricklet_type_b_address_and_unit>`.
To switch a type C socket you have to give the system code, device code and the state (on or off) you want to switch to.
A detailed description on how you can figure out the system and device code can be found :ref:`here <remote_switch_bricklet_type_c_system_and_device_code>`.
Returns the UID, the UID where the Bricklet is connected to, the position, the hardware and firmware version as well as the device identifier.
The position can be 'a', 'b', 'c', 'd', 'e', 'f', 'g' or 'h' (Bricklet Port). A Bricklet connected to an :ref:`Isolator Bricklet <isolator_bricklet>` is always at position 'z'.
The device identifier numbers can be found :ref:`here <device_identifier>`. |device_identifier_constant|
To install Tinkerforge, copy and paste the appropriate command in to your terminal.
cpanm
cpanm Tinkerforge
CPAN shell
perl -MCPAN -e shell install Tinkerforge
For more information on module installation, please visit the detailed CPAN module installation guide.