NexStarCtl version 0.13
=======================
This module implements the serial commands supported by the Celestron
NexStar hand control. This applies to the NexStar GPS, NexStar GPS-SA,
NexStar iSeries, NexStar SE Series, NexStar GT, CPC, SLT, Advanced-VX,
Advanced-GT, and CGE mounts.
Communication to the hand control is 9600 bits/sec, no parity and one
stop bit via the RS-232 port on the base of the hand control.
Communication can be established over TCP/IP if nexbridge is running
on the computer connected to the telescope.
INSTALLATION
To install this module type the following:
perl Makefile.PL
make
make test
make install
DEPENDENCIES
Device::SerialPort
Time::Local
COPYRIGHT AND LICENCE
Copyright (C) 2013 by Rumen G.Bogdanovski
This library is free software; you can redistribute it and/or modify
it under the same terms as Perl itself, either Perl version 5.12.4 or,
at your option, any later version of Perl 5 you may have available.