Test::Harness - run perl standard test scripts with statistics
Perl test scripts print to standard output
"ok N" for each single test, where
N is an increasing sequence of integers. The first line output by a standard test script is
M being the number of tests that should be run within the test script. Test::Harness::runtests(@tests) runs all the testscripts named as arguments and checks standard output for the expected
"ok N" strings.
After all tests have been performed, runtests() prints some performance statistics that are computed by the Benchmark module.
Any output from the testscript to standard error is ignored and bypassed, thus will be seen by the user. Lines written to standard output containing
/^(not\s+)?ok\b/ are interpreted as feedback for runtests(). All other lines are discarded.
It is tolerated if the test numbers after
ok are omitted. In this case Test::Harness maintains temporarily its own counter until the script supplies test numbers again. So the following test script
print <<END; 1..6 not ok ok not ok ok ok END
FAILED tests 1, 3, 6 Failed 3/6 tests, 50.00% okay
The global variable $Test::Harness::verbose is exportable and can be used to let runtests() display the standard output of the script without altering the behavior otherwise.
The global variable $Test::Harness::switches is exportable and can be used to set perl command line options used for running the test script(s). The default value is
&runtests is exported by Test::Harness per default.
All tests successful.\nFiles=%d, Tests=%d, %s
If all tests are successful some statistics about the performance are printed.
FAILED tests %s\n\tFailed %d/%d tests, %.2f%% okay.
For any single script that has failing subtests statistics like the above are printed.
Test returned status %d (wstat %d)
Scripts that return a non-zero exit status, both
$? >> 8and
$?are printed in a message similar to the above.
Failed 1 test, %.2f%% okay. %s
Failed %d/%d tests, %.2f%% okay. %s
If not all tests were successful, the script dies with one of the above messages.
See Benchmark for the underlying timing routines.
Either Tim Bunce or Andreas Koenig, we don't know. What we know for sure is, that it was inspired by Larry Wall's TEST script that came with perl distributions for ages. Numerous anonymous contributors exist. Current maintainer is Andreas Koenig.
Test::Harness uses $^X to determine the perl binary to run the tests with. Test scripts running via the shebang (
#!) line may not be portable because $^X is not consistent for shebang scripts across platforms. This is no problem when Test::Harness is run with an absolute path to the perl binary or when $^X can be found in the path.