WebService::Pushover - interface to Pushover API
This document describes WebService::Pushover version 0.0.6.
my $push = WebService::Pushover->new
or die( "Unable to instantiate WebService::Pushover.\n" );
my %params = (
token => 'PUSHOVER API TOKEN',
user => 'PUSHOVER USER TOKEN',
message => 'test test test',
my $status = $push->push( %params );
This module provides a Perl wrapper around the Pushover ( http://pushover.net ) RESTful API. You'll need to register with Pushover to obtain an API token for yourself and for your application before you'll be able to do anything with this module.
Inherited from WebService::Simple, and takes all the same arguments; you shouldn't need to pass any under normal use.
push() sends a message to Pushover and returns a scalar reference representation of the message status. The following are valid parameters:
The Pushover application token, obtained by registering at http://pushover.net/apps.
The Pushover user token, obtained by registering at http://pushover.net.
The Pushover device name; if not supplied, the message will go to all devices registered to the user token.
A string that will appear as the title of the message; if not supplied, the name of the application registered to the application token will appear.
A string that will appear as the body of the message.
The desired message timestamp, in Unix epoch seconds.
Set this value to "1" to mark the message as high priority, set it to "-1" to mark the message as low priority, or set it to "0" or leave it unset for standard priority.
A string that will be attached to the message as a supplementary URL.
A string that will be displayed as the title of any supplementary URL.
Inspect the value returned by push(), which will be a Perl data structure parsed from the JSON response returned by the Pushover API. Under normal operation it will contain one key, "status", with a value of "1"; in the event of an error, there will also be an "errors" key.
No bugs have been reported.
Please report any bugs or feature requests to firstname.lastname@example.org, or through the web interface at http://rt.cpan.org.
Steve Huff <email@example.com>
Copyright (c) 2012, Steve Huff <firstname.lastname@example.org>. All rights reserved.
This module is free software; you can redistribute it and/or modify it under the same terms as Perl itself. See perlartistic.
BECAUSE THIS SOFTWARE IS LICENSED FREE OF CHARGE, THERE IS NO WARRANTY FOR THE SOFTWARE, TO THE EXTENT PERMITTED BY APPLICABLE LAW. EXCEPT WHEN OTHERWISE STATED IN WRITING THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE THE SOFTWARE "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE SOFTWARE IS WITH YOU. SHOULD THE SOFTWARE PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR, OR CORRECTION.
IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY COPYRIGHT HOLDER, OR ANY OTHER PARTY WHO MAY MODIFY AND/OR REDISTRIBUTE THE SOFTWARE AS PERMITTED BY THE ABOVE LICENCE, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE SOFTWARE (INCLUDING BUT NOT LIMITED TO LOSS OF DATA OR DATA BEING RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE SOFTWARE TO OPERATE WITH ANY OTHER SOFTWARE), EVEN IF SUCH HOLDER OR OTHER PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
To install WebService::Pushover, copy and paste the appropriate command in to your terminal.
perl -MCPAN -e shell
For more information on module installation, please visit the detailed CPAN module installation guide.