RPi::SPI - Communicate with devices over the Serial Peripheral Interface (SPI) bus on Raspberry Pi
# channel 0 and 1 are the hardware SPI pins
# CE0 and CE1
my $spi = RPi::SPI->new(0);
my $buf = [0x01, 0x02];
my $len = 2;
my @data = $spi->rw($buf, $len);
# use a GPIO pin to expand the number of SPI
# channels. We'll bit-bang automatically. The
# GPIO pin must connect to the CS/SS pin on the
# IC you're using
$spi = RPi::SPI->new(26); # GPIO 26 is the CS
This distribution provides you the ability to communicate with devices attached to the channels on the Serial Peripheral Interface (SPI) bus. Although it was designed for the Raspberry Pi, that's not a hard requirement, and it should work on any Unix-type system that has support for SPI.
You can use the hardware SPI pins CE0 and CE1 on the Raspberry Pi, but if you need more SPI slaves, we'll also automatically bit-bang the SPI bus using a standard GPIO pin for the Slave Select instead.
Instantiates a new RPi::SPI instance, prepares a specific SPI bus channel for use, then returns the object.
The SPI bus channel to initialize.
Mandatory: Integer, 0 for /dev/spidev0.0 or 1 for /dev/spidev0.1. You can also send in any number above 1. If so, we'll treat it as a GPIO pin (connected to the CS/SS pin of the IC), and we'll bit-bang the CS automatically as to free up the onboard hardware channels.
Optional, Integer. The data rate to communicate on the bus using. Defaults to 1000000 (1MHz).
Dies if we can't open the SPI bus.
Writes specified data to the bus on the channel specified in new(), then after completion, does a read of the bus and re-populates the write buffer with the freshly read data, and returns it as an array.
Mandatory: Array reference where each element is an unsigned char (0-255). This array is the write buffer; the data we'll be sending to the SPI bus.
Mandatory: Integer, the number of array elements in the $buf parameter sent in above.
Return: The write buffer, after being re-populated with the read data, as a Perl array.
Steve Bertrand, <steveb at cpan.org>
<steveb at cpan.org>
Copyright 2017,2018 Steve Bertrand.
This program is free software; you can redistribute it and/or modify it under the terms of either: the GNU General Public License as published by the Free Software Foundation; or the Artistic License.
See http://dev.perl.org/licenses/ for more information.
To install RPi::SPI, copy and paste the appropriate command in to your terminal.
perl -MCPAN -e shell
For more information on module installation, please visit the detailed CPAN module installation guide.