Net::SSLGlue::FTP - extend Net::FTP for FTPS (SSL) and IPv6
# SSL right from start
my $ftps = Net::FTP->new( $host,
SSL => 1,
SSL_ca_path => ...
# SSL through upgrade of plain connection
my $ftp = Net::FTP->new( $host );
$ftp->starttls( SSL_ca_path => ... );
# change protection mode to unencrypted|encrypted
$ftp->prot('C'); # clear
$ftp->prot('P'); # protected
Net::SSLGlue::FTP extends Net::FTP so one can either start directly with SSL or switch later to SSL using starttls method (AUTH TLS command). If IO::Socket::IP or IO::Socket::INET6 are installed it will also transparently use IPv6.
By default it will take care to verify the certificate according to the rules for FTP implemented in IO::Socket::SSL.
The method new of Net::FTP is now able to start directly with SSL when the argument <SSL = 1>> is given. One can give the usual SSL_* parameter of IO::Socket::SSL to Net::FTP::new.
If the connection is not yet SSLified it will issue the "AUTH TLS" command and change the object, so that SSL will now be used.
Once the SSL connection is established you can use this method to get information about the certificate. See the IO::Socket::SSL documentation.
All of these methods can take the SSL_* parameter from IO::Socket::SSL to change the behavior of the SSL connection. The following parameters are especially useful:
Specifies the path or a file where the CAs used for checking the certificates are located. This is typically "etc/ssl/certs" on UNIX systems.
If set to 0, verification of the certificate will be disabled. By default it is set to 1 which means that the peer certificate is checked.
Usually the name given as the hostname in the constructor is used to verify the identity of the certificate. If you want to check the certificate against another name you can specify it with this parameter.
IO::Socket::SSL, Net::FTP, Net::SSLGlue::Socket
This module is copyright (c) 2013, Steffen Ullrich. All Rights Reserved. This module is free software. It may be used, redistributed and/or modified under the same terms as Perl itself.
To install Net::SSLGlue, copy and paste the appropriate command in to your terminal.
perl -MCPAN -e shell
For more information on module installation, please visit the detailed CPAN module installation guide.